Mini Birdfeeder Pins for Swapping
- #20 Hemp
- Black Vinyl Tape
- Safety Pins
- Mini Plastic Cups with Lids
- Mini Craft Sticks
- Low Temp Glue Gun
- Large Nail
- SWAP* Tags (not shown) (optional)
Use a large nail to make two holes in the mini pot lid. String a 5″ piece of hemp through a safety pin and push each end of the cord through a hole in the lid. Tie in a double knot on the underside. Pull tight. Put a dab of glue on the knot and trim ends close to knot. Fill the mini plastic cup with birdseed and place the modified lid on top.
Cut a small curved piece of vinyl tape to make a fake opening in the feeder. Hot glue a mini craft stick to the bottom to make a perch.
If you are using optional SWAP* tags, write your message on the tag and slide onto the pin. Close pin.
12 Per pack