|
 Rattlesnake Zipper Pull
Clip a rattlesnake to your
backpack or your key ring.
You need:
Instructions:
Print pattern. Staple a snake
pattern to a piece of imitation leather all around the outside of
the outer line. First cut the two slits in the tail and punch
out the eyes and hole near the mouth. Then cut all around on the
outside line.
Tape the head of the snake to your work surface. Braid the the
three strips. Folding the pieces over as you braid will create the
striped effect shown above. Rubber band the tail about 2" from the
end. Trim two of the strips close to the rubber band. Fold the
remaining strip in half lengthwise and push three pony beads up to
the rubber band. Trim this strip to a round point.
Remove masking tape. Feed a lanyard hook through the mouth hole.
©©2005 MakingFriends.com, Inc. All rights
reserved. |
